Dedicated Mircros Digital Sprite 2 Einstellungsanleitung Seite 45
- Seite / 130
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
Dedicated Micros ©2006
45
DS2 Network Guide
Global Alarm It is possible to congure any of the onboard or additional module
relays to be the default global alarm relay, this means that the
relay will close when an alarm is received on any of the alarm
inputs.
Global VMD It is possible to congure any of the onboard or additional module
relays to be the default global VMD relay, this means that the
relay will close when VMD is identied on any of the camera
inputs.
Global Camera Fail It is possible to congure any of the onboard or additional module
relays to be the default global camera fail relay, this means that
the relay will close when there is notication on the system that
any of the enabled video inputs has camera failure (no 1V pk-to-
pk signal).
Schedule Notication The schedule notication relay will identify when the unit has
switched out of Day mode operation (i.e. when switching to Night
or Weekend mode). It is possible to congure any of the onboard
or additional module relays as the Schedule Notication relay.
Primary Signalling Failure The unit can transmit an alarm to a central station via a primary
route, if for any reason the alarm is unable to send this message
via this route the corresponding relay will close. It is possible to
select any of the onboard or additional module relays.
Weekend Notication The unit will close the corresponding relay when the unit switches
to weekend mode operation.
How to Congure Connect/ Dial, FTP, SMS and E-mail on Alarm
As described in the Alarm Zone section above there are a number of actions that can be initiated
when the unit is in receipt of an alarm trigger.
For these actions to operate correctly there are additional conguration requirements; FTP server
address, SMS / GSM settings and SMTP Server address. Without this information the unit would not
have a route to transmit images on receipt of an alarm or notication of VMD. This section will be
separated into the conguration processes required to enable these functions to operate.
How to Congure Connect/Dial on Alarm
It is possible to force the unit to transmit a message to an allocated Viewer on receipt of an alarm.
This connection can be via the Ethernet port of the unit or via a dial up connection on the serial port
of the unit.
The message will be transmitted to the remote station to notify them of an alarm on the system. The
operator can then make a connection to the unit to verify and action the alarm response.
There are two modes of conguration depending on the route of the alarm message. For Ethernet
the system can be congured wholly using the web interface pages, when using the modem link,
also referred to as PPP (Point to Point Protocol) then it is necessary to edit the ‘prole’ le within the
\etc directory of the unit.
At this stage it is presumed that the unit; is installed with a modem connected to a serial port and/or
is connected to the Ethernet network and has been allocated an IP address but the serial port has
not been enabled for PPP.
This section will be separated into:
ProForm 831.24755.0 podręczniki
Instrukcje obsługi i podręczniki użytkownika dla Sport i rekreacja ProForm 831.24755.0.
Dostarczamy 1 pdf podręczników ProForm 831.24755.0 do pobrania za darmo według typów dokumentów: Instrukcja Użytkownika
Kommentare zu diesen Handbüchern